Kafuter-5211H Thermal&Heat Conductive Silicon Rubber Gel For LED Lights,Bulbs,Lanterns

 FEATURES

 K-5211H is a gel ointment was compounded by metal oxide (with great thermal conductivity& insulation) and organic siloxane.

 Good performance of thermal conductivity (1.2 refractive index) and electrical insulation.

 Long working temperature (-50°c ~ +200°c)

 Higher thixotropic, better elevation coating, and excellent stable properties

 No toxic or corrosion,  and not dry or dissolve.

 APPLICATION

 Function: Export the heat from components and reduce its working temperature

                  Filling and coating in the electronics, electrical appliance and components.

 Such as: the gap of CPU and radiator, high-power transistor, silicon controlled components

                 the gap between diode and the surface of substrate (aluminum, cooper)

                 the contacted surface between trial PA tube and thermal fin

                 semi-conductors, and heating components.

 Apply in bonding and sealing in LED washing wall light, spotlight, daylight bulbs, and other lights, lanterns, or candles.

 TYPICAL PROPERTIES 

  HOW TO USE

 Preparation

 Clean the coating surface and remove the oil and grease.

 Application

 Squeeze out the thermally conductive silicon grease, and directly coating into the uncoated surface with a thin layer.

 The coating ways: brushing, scraping, or roll coating

 Attention

The surface should coat evenly by filling the whole gap with a fully thin layer. And make sure not coat too much on the surface.

 PACKAGING   80g/ tube 

 STORAGE

Store in cool and dry place, the shelf life is 18 months (≤25°c)